V8 Eater!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

[NOS388]

I don't known if any one has covered this or not?
i am building a holden 6cyl (blue motor) and i plan to fit the EFI off a VK. can it be done? what other upgrades must be made with the EFI setup. will the intake plenum fit with extactors?
what would be good throtle bodies to replace the stock one?
would it be viable to fit two throtle bodies?
:( ;) :) :D ;) :p :mad: :rolleyes: :cool: :eek: :confused:

[Jim]

the EFI VK came out with factory extractors. These are ok, but not the best.

the stock EFI setup is an early variety and a small step ahead of a carb setup, but with an aftermarket ECU they seem to respond fairly well.

As for the rest of the mods, how fast do u want to spend? Whats your budget?

[NOS388]

what i was going to do first was install the EFI, extactors(can you fit extactors other then the stock set?), cam, 2 1/2 exhaust.
Then later on after that stronger internals (e.g pistons, crankshaft, conrods, intake&exhaust valves, sump, lightened flywheel, comp raised etc).

[Jim]

yep, reasonable way to go...

yep, in fact after market extractors are easier to fit on an efi VK as the inlet sits quite high and doesnt foul the pipes.