Haltech E6S software, where to get?

[Optional]

HI,

would anyone on here be able to send me the Haltech E6S programming software, please? In one of the older threads DYNOSTEVE could help with the F9A software. Is there anyone who can supply the E6S software, or do you have the E6S software too, DYNOSTEVE?

regards

Den

[dillon]

I have a version of E6S that used to be on their site. It is just over the maximum allowed file size for this forum.
Send me an email to get it.

_________________________________________________


How to use the demo software :

When the software is loaded, select ‘y’ for online. This the software
This will simulate the software working on an engine in real time.

To select options shown at the top of page use the ‘alt’ key and the
Underlined letter.

To make changes in any page, use the ‘tab’ key.

In the main setup page, you can select which map sensor you have. For a naturally aspirated engine, you would use a 1 bar map sensor. In this mode you can not select any of the features for a turbo / supercharged engine.

If you select 2 or 3 bar map sensor, then you can access the turbo options.
Go to the output options and you can see some of the features of the Haltech. If you select Turbo Wastegate control, then go to maps (alt m) and have a look at the wastegate maps to see how it programmed.

There are many other features which you will find by playing around.
__________________________________________________

[DYNOSTEVE]

i have the software at work email me at rdpracing@bigpond.com and i'll send it to you.

[JEM]

Dillon,

the demo software instructions look familiar:D

Regards
Adam N
Just Engine Management

[dillon]

So it should, it's their demo instructions !
(that's why there's a line between mine and their writing)