Results 1 to 4 of 4

Thread: Haltech elite dtm can wiring.

  1. #1
    Registered User
    Join Date
    Nov 2016
    Location
    geelong Australia
    Posts
    74

    Haltech elite dtm can wiring.

    Hi just wondering if someone can help me out.
    I've got a can hub and gauge art can gauge on it's way from haltech as we speak and I wanted to connect it to the can harness wires to a dtm deuch connector that's compatible with the haltech can hub.
    Could someone please give me the correct pin locations for the 4 wires needed?
    I've got the generic wiring schematic but dosnt specify what goes to what pin.
    Thanks in advance
    Cheers Dale

    Sent from my SM-N950F using Tapatalk

  2. #2
    I'm not a real engineer taijohnsen's Avatar
    Join Date
    Aug 2014
    Location
    Australia
    Posts
    36
    https://files.haltech.com/downloads/...rmation_V1.pdf

    The hub should follow the same as the ECU, and if they don't, that's stupid..

    Can always check with DMM...

    12V and GND is easy, and it doesn't matter if CAN HI and LO are reversed, it just won't work if they are.

  3. #3
    Registered User
    Join Date
    Nov 2016
    Location
    geelong Australia
    Posts
    74
    Exactly what I was after.
    Thanks very much.
    I take it that is front view of a male connector yes?


    Sent from my SM-N950F using Tapatalk

  4. #4
    Registered User
    Join Date
    Nov 2016
    Location
    geelong Australia
    Posts
    74
    The 12v and ground must come from the haltech connector to or is auxiliary 12v and ground ok?

    Sent from my SM-N950F using Tapatalk

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •