BOSS 335 GT Runs 12s

[blue_cefiro]

definatly one of the best pf threads in awhile. well done.

[2rismo]

torque at 2300 is 452nm
3000 505nm
3500 508nm
4000 528nm
4500 523nm
5000 537nm

and they run fucking rich.. like 10.5:1 at wot in the top end..

Torque in Nm from a chassis dyno still confuses me. Do your results suggest that the engine is making nearly as much torque at the tyres as they quote for the flywheel?

[10sec rx7]

if they had a vac source hooked up to the im and it said 7.1psi i doubt it will come with any less boost stock. Talk od bypass valves, pullys etc is pointless.

Its a supercharged 5l v8 is 330ishrwkw's really that hard to believe. Ford have just underrated the figures so the rumours about the car turn out good rather than bad. Some marketing guy at ford has gone it will create talk/publicity to have lower rated figures and higher real world figures. After all it worked with the original xr6

bypass valve is only for low throttle to bypass the blower to make them drive better... nothing to do with WOT

[Mr Ed]

and they run fucking rich.. like 10.5:1 at wot in the top end..

Same on this one and normal ones?

[10sec rx7]

Torque in Nm from a chassis dyno still confuses me. Do your results suggest that the engine is making nearly as much torque at the tyres as they quote for the flywheel?

that is flywheel torque.. my dyno caculates it from real engine RPM.. it only works with the tacho adaptor plugged into the engine..

[2rismo]

that is flywheel torque.. my dyno caculates it from real engine RPM.. it only works with the tacho adaptor plugged into the engine..

Gotchya.

[10sec rx7]

overdrive bottom pulley wouldn't be that hard for FPV ( I have one for my VT) and would be harder to notice. 77 mm on the blower isn't that small- M90's have pulleys going down to 64 mm.

you could probably go to 73mm before you hit the snout on the blower..

[GSRman]

when are the first ones on sale? - will be interesting to see what they run.

have to say, that car (with the 330+rwkw) sounds like a fucking bag of fun.

[BundyBeej]

So... estimates on the potential output after a bit of a tune?? :D

[BENN0]

The guys on here with Ford turbos: Is it needing 330 atw to run a 12.9?
I would have thought that with 330rwkw these things would run a low 12 at 118-120mph.

I wonder how many GT's will be sold because of this thread? A genuine 330atw stock is fantastic!

[10sec rx7]

What was it at peak power and peak torque?

wait till the cunts get back with the dyno sheets

[rowdytoot]

so the new blowers have bigger snouts ....

in any case running rich. 8.5 pound and 320 + rwkw stock is pretty freaking good I reckon :D

[10sec rx7]

i reckon 400rwkw with a intercooler and a little boost...

BTW BF GT 234rwkw stock...

[GSRman]

i reckon 400rwkw with a intercooler and a little boost...

BTW BF GT 234rwkw stock...

yeah, they don't like the FG turbos



Don't suppose anyone measured the bottom pulley?

[QABB]

I wonder how many GT's will be sold because of this thread? A genuine 330atw stock is fantastic!

Gotta say, it's getting my interest level up!