Black Box PDM's

[ROBAPHENT]

Also interested, when I rang motec they did say some people but two 15s one in the front one in the back.

This is an option i was looking at. i know https://www.facebook.com/Integrated-...3680805264766/ runs that setup.

[10sec rx7]

that's a lot of money to save running a few wires to the back of the car..

[sssgtr]

A lot of off-road guys run 2 x PDM's for that convenience and extra overall amperage capacity.

I can *just* get by with 1 x PDM15, but leaves no room on the table.

PDM30 at least affords a couple of higher 16a outputs when pairing together a couple of the 22 x 8a channels.

[10sec rx7]

I get it, but everything I have done with PDMs has gone no where near maxing out the racepak units, with them using a higher rated connector can do 40amps with 2 channels.

[sssgtr]

Anyone with insider knowledge know if/when Motec are updating their PDM range?

I'm guessing no time soon?

[burn is weird]

maybe PM cossie55

[10sec rx7]

hes not at motec any more,

word is there is no update anytime soon

[sssgtr]

Hmmm ok. Similar to what I've heard too.

What's the ECUMaster PMU16 like for anyone who is using one?

[10sec rx7]

all reports they are suppose to be ok... but I have not used one... ive only used motec and racepak

[sssgtr]

Circling back around to the P30 after speaking to one of their Vic distributors this morning, who rates it over the PDM30.

Any user feedback from here?

[glenn]

How much is the P30? I have the P12 in my FD and its good.

[sssgtr]

About $2200 for the CAN enabled version. Don't need a $200 UTC adaptor to program it either.

[sssgtr]

https://www.ecumaster.com/products/p...sport-version/

Thoughts?

Approx $2800 AUD with all Autosport and Radlok connectors.

[ROBAPHENT]

https://www.ecumaster.com/products/p...sport-version/

Thoughts?

Approx $2800 AUD with all Autosport and Radlok connectors.

I'm to poor for this.

[sssgtr]

It's currently conflicting my decision making for a PDM.