R zeddys fabrication corner, want something done?

[Marlin]

Lots*.
Yep.


* Kinda.

yep hoist available, no long term because not my shed.

Thanks gents. How long is "long term"? I'd only want you to have it for as long as you needed it.
I need to get my head around what needs prioritizing on this car.

[Rz]

a couple weeks max.
what kinda stuff needs to be done?

[doctor ed]

skippy yeh, for that id link a coupe cast 3 inch bends together, i have a source for them.
doctor ed, depends on the construction, at least 500 a side. head mating flanges and w/gate config?
commotion here or kyle would prob quote you better.

just meant the collector bit really, but have dropped damien an email none the less - didnt realise he's a collector magician

[Kris]

Hey Rz,

Should have posted in here, looking for a oil temp sensor adapter, M6 for the sensor , i guess aluminium tube (will confirm inlet/exit) OD's tonight. needs ribbing on the end or a flange so the hose can slip over and tighten down nicely..

Can you assist please?

[Rz]

yeh can do, draw on paper or something and post pic.

[Kris]

OK, here is my dodgy sketch



Here is the sensor specs, which shows the height of the threaded section required

http://www.kasensors.com/sites/defau...NTC1.412aU.pdf

(Mines M6)

[Marlin]

a couple weeks max.
what kinda stuff needs to be done?

Sorry missed the reply.
Mount fuel cells, tidy up some stuff up front in the bay, maybe some heat shields and scallop/clearance K frame etc.
Modify sump too. That kind of stuff.

[Rz]

right got it. ill have a go tommorow.

[Rz]

Sorry missed the reply.
Mount fuel cells, tidy up some stuff up front in the bay, maybe some heat shields and scallop/clearance K frame etc.
Modify sump too. That kind of stuff.

allrighty. just pm when your ready.

[Marlin]

Shall do. Simple stuff but I'm time poor, no gear, and fading skills. Lol

[Kris]

right got it. ill have a go tommorow.

If that was meant for me OK thank you!

[Rz]

yep I got on list of shit to do

[Rz]

job 5.
reroute 265 extractors around new gearbox/starter position. a shitload of cuttin' and shuttin'

[Rz]

kris ill make that t piece first thing tommorow and post it.

[Kris]

Mate, no hurry as I haven't received the sensor yet and im at Phillip Island all week