Haltech E6K ECUs

[tim510]

Walbro 460 / 525's are good pumps but their electrical needs can be an issue. You need to be really mindful of how well you wire them, the gauge of wire, the type of fuse terminals used. Blade type fuses seem to melt, not blow the element.
...

[tim510]

The Bosch 540 looks like a neat pump. Your wiring can support a larger pump fine....

[tim510]

Go to the diagnostic tab while cranking and it will tell you if it has trigger sync 'full' or not. if you don't have full trigger sync you'll get no ignition output.

Also your battery voltage and grounds need to be VERY good. the ECU...

[tim510]

what has been your process?

My questions would be?

1. Have you determined if you have trigger sync?


2. Have you configured the trigger offset by locking the timing and chased a timing mark with a timing...

[tim510]

First of all, confirm the ECU has trigger sync.

[tim510]

Over the weekend I spent some time sorting the planned turbo and exhaust manifold setup.

The old school j-pipe needed a few specific things to make it work.

- a 280zx L28e exhaust manifold
- a T04 flanged turbo
-...

[tim510]

This might help with fitting flat carpet. He has other videos too....

[tim510]

Pulsing the injectors while submerged in a ultra sonic is common. They use a solvent for cleaning.

Boiling water as an option is outstanding :D...

[tim510]

...

[tim510]

Just a on-off-on rocker i believe. The self cancelling window switches have additional smarts, probably too hard to retrofit. these would just need 12+ve and ground to work.

I wired a racecar this exact way earlier in the year. worked...

[tim510]

norbie, you can wire up a 6 pole ON-OFF-ON momentary with polarity reversing. its pretty simple.

https://au.element14.com/marquardt/0...YIgeqRBiXd7ftj...

[tim510]

Big dumb wheels have been purchased.

The car currently has 31x10.5r15 installed.

I wanted bigger tyres for some mild off-road adventures.

I’ve got a full set of basically brand new 33x12.5r15 tyres and some...

[tim510]

So the plan all along has been to install EFI and turbo this car.

My plan for doing this is to keep it cheap and cheerful.


So I've bought a collection of bits and pieces to click together a turbo kit for the old bus....

[tim510]

IC7 dash and a fuel level sender.

[tim510]

Awesome build, even though its been done 11ty time, the old JZ cressida is a classic.


I'm guessing a total spend of around $30k?

[tim510]

give makita a call.

[tim510]

Under 10k

[tim510]

E6A - https://www.haltech.com/wp-admin/adm...9bb877304cdb72

E6K - https://www.haltech.com/wp-admin/adm...9bb87ba8602542

my work here is done....

[tim510]

PF dudes,

Selling some stuff from the shed to fund a project.

I have 2x Haltech E6K ecus.

Both have a short harness and ecu connector.

$200 ono each.

https://www.fueltech.com.au/pdf...

[tim510]

I'm probably going to use a different manifold. Forced induction will fix any short comings....