User Profile

[[RX3]]

Now that I think about it I am not too sure how that would go doing lobster cuts less than 10 degrees as there seem to be intents which might cause the blade to cut into he metal support if cutting at angles between zero and 10 degrees. Maybe keep that...

[[RX3]]

https://www.machineryhouse.com.au/B062V

Non dual mitre might be a good option for you too as its a bit cheaper, albeit on sale.

[[RX3]]

IMO if I was to buy another I would get something like this,

https://www.machineryhouse.com.au/B063V

Thicker / taller blade gives a lot less cutting deflection and I like how the cutting piece is supported by the metal stop...