User Profile

[StupidFlanders]

They have Will Brown. Maybe Brodie Kostecki too?...

[StupidFlanders]

Lots, I’m a slow worker. I stopped halfway through today to watch the boy have a go in the Jolly Jumper. Then I had to go get my ladder back from my brother so I could get out a specific spanner I had stored in the roof to lock the cams while I did...

[StupidFlanders]

Been a bit uneasy for a couple of days wondering if the new pistons were going to clear the valves. The internet reckons they should. The engine builder reckons they should. So today I whacked on the head and timing chains, spun it over a few times........

[StupidFlanders]

Block honed and decked, crank linished, rods closed and honed and ARP bolts, new bearings, new pistons, bottom end balanced along with the new solid S15 flywheel and clutch, head shaved, valve seats done, exhaust valve guides replaced, Camtech 270°...

[StupidFlanders]

Picked up the fresh replacement SR today.

...

[StupidFlanders]

I had a guided tour of the President last week. It’s quite a machine!...

[StupidFlanders]

5k?! Hot damn, I was going to sell my SR turbo engine and box for 4k. I’m going to jack up the price....

[StupidFlanders]

I read them a bit just to get an idea on how I’m travelling in life. It’s a nice little leg up for the self esteem- “at least I’m not as dumb as these cunts”.

[StupidFlanders]

People have short memories. The LS1 HQ racecar wasn’t revealed as being a sponsored car for a Supercheap ad for a few episodes. Who cares? Bunch of precious cunts out there. I don’t get offended or feel like I got duped. It’s entertainment. For...

[StupidFlanders]

Shims cost about $12. No more peg leg....

[StupidFlanders]

You’re going to scrape the underside of the front bar when you do an endo on the first hard stop....

[StupidFlanders]

Jesus, that good!

FYI I tried to buy a stage 1 Mantic but got fucked around with one seller as there appears to be no stock. I ended up going with your favourite Extreme Clutch. I haven’t had dramas with them so far....

[StupidFlanders]

Benny at BCW has one of the Nissan Utes. Well he did a few months ago, not sure if he still does. It looked pretty clean and was unreg, he was going to use it for a project but had gone off that idea....

[StupidFlanders]

Mad car! Good pick up.

It will feel pretty quick, I had the same setup in my S13 with the same power and it went ok, you’ve got a much lighter car there....