andy_wk
Succulent Chinese meal
Last Activity: 21-01-20, 10:11 PM
Joined: 06-11-17
Location: Brisbane
-
-
OEM are fluid filled FWIW.
I was recommended to stick with OEM for longevity/reduced NVH compared to the cheap rubber ones. Has been in for around 40,000km, and half of that time with a high...Last edited by andy_wk; 15-01-20, 04:08 PM.Leave a comment:
-
Yep have used the epoxy stuff to repair pinhole leaks in a fuel tank (while it was still leaking out), it outlasted the rest of the car. Soldering basically impossible with oil contamination all over...Leave a comment:
-
Lee Brothers at Albion. Re-did my headlining at a good price, all looks factory. Quote was very reasonable for rebolstering/dying a worn leather driver's seat too, just haven't had the time/motivation...Leave a comment:
-
DCI make good stuff that's automotive focused:
http://dciperformance.com.au
http://dciperformance.com.au/product...ose+ProtectionLast edited by andy_wk; 05-01-20, 12:22 PM.Leave a comment:
-
The red looks great. Pretty much all the ones I see these days are silver or black.Leave a comment:
-
I'd wager that if you got it dialled in properly (ie to the grinder's specs) you'd get gains everywhere (with the only exception being the peak power figure on the dyno, which might come down to a more...Leave a comment:
-
Did any of the involved shops check the cam timing? Not just 'line the dots up', but properly using a degree wheel? (This would've taken a few hours labour...)
218/226 and 116LSA isn't exactly...Last edited by andy_wk; 30-12-19, 04:20 PM.Leave a comment:
No activity results to display
Leave a comment: