User Profile

[mizone]

I'm starting to think Holden will arse this up.

Cost of 911 in USA -> https://www.porsche.com/usa/models/911/ USD $100k (including taxes and destination) or ~ AUD $147k Say $160...

[mizone]

Tipper, your best bet is a to call a importer and ask them whats required as of today. They will be bringing cars in and will know the senarios.

[mizone]

That link is pretty cool. This guys setup is neat (Aim for this) but I can't see how hes mounted the front. Note the rear holes I was mentioning.


My biggest headfuck was pulley alignment....

[mizone]

Why don't people clean their cars of junk when preparing them for sale? Inside looks like a meth addicts lounge room with a Ventolin inhaler and crap. Not the worst I've seen, but the owner is claiming...

[mizone]

Yep, IIRC there are two holes at the front one above and one below the input shaft. You can make up a bracket to go around the input shaft and that then goes to your block for mounting. I strongly recommend...

[mizone]

Excellent to know....

[mizone]

Whoa, when did kW per tonne come in?

Also you in SW Metro or well south? Wondering where the weighbridges are......

[mizone]

That front pulley comes off easily (or did you say you ordered it separately?) and offers a flat area for the bracket. You just need to drill holes and be away. Alas, the Ford motors are a headfuck with...

[mizone]

I haven't know anyone at a Holden dealer for a while. As mentioned elsewhere they seem to be all turning into Suzuki, Kia and other multi-brand dealerships. I think theres only two left I know of SOR,...

[mizone]

Excuse my "I dont' speak 4WD diesel" but isn't 430NM a bit low a number to pull such a large vehicle?

[mizone]

Whoohoo it's back and running again.

Don't worry about not painting it, so long as the metals protected from rusting, drive the thing and have fun.

[mizone]

One of these pumps?



If so I has one in my car, let me know what measurements you require....

[mizone]

Mal Wood does these for Falcons. Might fit under the dash in the G-mini.

https://malwoodauto.com.au/wp-conten...ssembly_v3.jpg...

[mizone]

Goolsby's 1974 Duster named Kasper with HellCat Power. Never was a fan of Dusters nor stripes but this looks good to me. Anyone know what Goolsby's work is like?


...

[mizone]

Can that be modified to suit your needs no13b_Coupe?...

[mizone]

Accelerator pedal I'll live with, the rust in that door sill though......

[mizone]

Thats more likely that the dealer doesn't know if they will be a Holden dealer for much longer....

[mizone]

So I thought of doing a hydraulic conversion to the Mustang. Everyone is telling be it's a piece of piss and only a couple of hundred bucks...

Bullshit.

I reckon if you're going...

[mizone]

...

[mizone]

They are in old Panasonic colours as well. Bizzare....